How do I know if my hot tub circuit board is bad?
If you DO have 220 volts across both hot wires coming from the house, then next measure the voltage across both heating element pins. You should see 220 volts. If you do not, then the circuit board is faulty and will need to be replaced or sent to us for repair.
How do I test a hot tub circuit board?
HydroQuip circuit boards has a part number on a large white label placed directly on the circuit board. To properly identify the correct HydroQuip board, simply search the part number on the label. Gecko circuit boards have chip numbers located on a label on the outside of your spa pack.
How do I reset my Balboa hot tub control panel?
Remove the spa cover and allow water to cool. At 107¡F (approximately 41.7¡C), the spa should automatically reset. If spa does not reset, shut off the power to the spa. Standby Mode has been activated by pressing a button combination on the user panel.
How much is a new motherboard for a hot tub?
Repairing a hot tub motherboard costs $150 to $450. The motherboard can also be referred to as the control board or circuit board. It is responsible for controlling the various functions and processes of your tub, allowing the jets to function, the water to flow, and the heater to turn on.
How much does it cost to replace a hot tub circuit board?
Replacing a hot tub circuit board averages $350 to $1,000, depending on the make and model. The circuit board is one of the most expensive hot tub components, so this can be a costly job. It may require a lot of labor for a repairman to take the tub apart and access the area where the new board needs to be installed.
What is the model number of Balboa water group circuit board?
Balboa Water Group Circuit Board VS500 Systems 54369-01, 54369-02, 54369-03 Balboa Water Group Circuit Board VS500 Systems 54369-01, 54369-02, 54369-03
How do I check the voltage output on my Balboa system?
UÊEven if the system is not equipped with a blower triac, the best way to verify voltage output is with the Balboa Quick Check. UÊIf the Quick Check light does not appear after pressing the appropriate panel button, trace the wires from the corresponding connector in the system box back to the circuit board.
How do I know if my Balboa topside control panel is working?
If your topside control panel is working properly, but a pump, blower, or other device does not activate when its panel button is pressed, further diagnosis is easily accomplished with the Balboa Quick Check, which is designed to test output voltage on a variety of Balboa systems.
Should I replace the circuit board on my VS500 board?
DO NOT REMOVE AND REPLACE THE CIRCUIT BOARD UNLESS YOU HAVE TESTED ALL OTHER COMPONENTS AND PROVEN THAT THE CIRCUIT BOARD IS ACTUALLY CAUSING THE PROBLEM. VS500 Board 43 Removing the Heater Assembly from a Spa System
https://www.youtube.com/watch?v=VYhUFOW6MXw